Brief Introduction

PSTX570-600-70

Technical parametersRated Operating Voltage:208 ... 690 V ACRated control supply voltage (U.)s):100 ... 250 V ACRated control circuit voltage (Uc):24 V DCRated Frequency (f):50/60 HzMain Circuit 50 / 60 HzRated Operating Power - Coaxial Connection (PE):(230 V) 160 kW(400 V) 315 kW(500 V) 400 kW(690 V) 560 kWRated Operating Current - Coaxial Connection (IE):570 ARated Operating Power - Inner Delta Connection:at 230 V 295 kWat 400 V 540 kWat 500 V 700 kWat 690 V 960 kWRated Operating Current - Inner Delta Connection:987 APercentage of Safety Factor:100 %Overload Protection:Built-in electronic overload protectionIntegrated Electronic Overload:YesStarting capacity at maximum rated current Ie:4xIe for 10sSlope Time:1 ... 120 second [unit of time]Initial voltage at start-up:10 ... 99 %Special Buck Ramps:100 ... 10 %Inner triangle connection switch:beRunning Signal Relay:beBypass Signal Relay:YesFault Signal Relays:YesOverload Signal Relay:beReady to start/standby signal indication ON (LED):GreenOperational signal indication R (LED):GreenProtection Signal Indication (LED):YellowFault Signal Indication (LED):RedCommunication:Modbus-RTU; Modbus-TCP; Ethernet-IP; EtherCAT; DeviceNet; CANopen; Profibus; Profinet; BACnet-IP; BACnet-MSTPIngress Protection:acc. to IEC 60529, IEC 60947-1, EN 60529 Main Terminals IP00Terminal Type:Main Circuit: BarsControl circuit connection capacity:Rigid 1 x 2.5 mm²Power supply circuit connection capacity:Rigid 1 x 2.5 mm²Tightening torque:Main Circuit 35 N·mProduct range:PSTX570Function:Auto phase sequence detectionAutomatic restartCurrent limitCurrent limit rampDual current limitDynamic brakeElectricity meteringElectronic overload Time-to-coolEmergency modeEvent logShow moreProtection Functions:Bypass open protection; Current imbalance protection; Current underload protection; Dual overload (separate overload for start and run); Earth fault protection / ground fault protection; Electronic overload protection, EOL; Extension IO failure protection; Fieldbus failure protection; HMI failure protection; Locked rotor protection; Max number of starts/hour; Over voltage protection; Phase reversal protection; Power factor underload protection; PT-100 connection; PTC connection; Too long current limit protection; Too long start time protection; Under voltage protection; User defined protection; Voltage imbalance protectionWarning Details:Current imbalance warning; Current underload warning; Electronic overload Time-to-trip; EOL warning; Faulty fan warning; Locked rotor warning; Motor runtime limit warning; Over voltage warning; Phase loss warning (for standby); Power factor underload warning; Short circuit warning (for Limp mode); THD(U) - Total Harmonic Distortion warning; Thyristor overload warning (SCR); Under voltage warning; Voltage imbalance warning