MODEL

VAT-UP200S-5-60L-AII

OUTPUT

DC Output

5V

Output Pre set voltage

4.95-5.05V (220Vac input, load 0A)

Rated Current

40A  ( PSU bottom fixed on heat sink of square > 250*250*2mm aluminum plate)

CurrentRange    Note 1

0~40A

Ripple and Noise

25~65℃

≤150mV

0~25C

≤200mV

Voltage Adj. Range

4.15~5.10V

Voltage Accuracy

±2.0%

Line Regulation

±0.5%

Load Regulation

±2.0%

Set-up Time

≤1.0S (220Vac input, Full load) & ≤2.5S (110VAC input, Full load)

Hold up Time

≥10mS(220Vac input , 80% load)

Temperature Coefficient

±0.03%/℃

Overshoot and Undershoot

<5%

INPUT

VoltageRange

90Vac~264Vac

FrequencyRange

47Hz~63Hz

Efficiency ( Typical)

89%(220Vac input ,full load)

AC Current (max.)

<2.5A

Inrush Current (Typical)

<80A@220Vac     Cold start

Power factor

PF>0.95/110VAC   &   PF>0.93/220VAC  (at full load)

PROTECTION

Over Power

225W~300W, Hiccup, auto recovery

Over Current

45A~60A, auto recovery

Shorted Circuit

Long-term mode, auto recovery

ENVIRONMENT

Operating amb. Temp. & Hum.

-40℃~65℃; 20%~90%RH No condensing  (refer to the derating curve)

Storage Temp. & Hum.

-40℃~85℃; 10%~95%RH No condensing

SAFETY &EMC

Note 3

Safety Standards

UL60950-1 2nd Ed; IEC 60950-1:2005(2nd Ed) ;EN60950-1:2006

Withstand Voltage

Primary-Secondary:3.0KVac/10mA .Primary-PG:1.5KVac/10mA. Secondary-PG:0.5KVDC/10mA.

Leakage Current

Input—output: ≤0.25mA    Input—PG: ≤3.5mA （264Vac input,）

Isolation Resistance

10Mohms

EMI Conduction & Radiation

Compliance to EN55022, EN55024, FCC PART 15  CLASS B

Harmonic Current

Compliance to EN61000-3-2 CLASS D

EMSImmunity

Compliance to EN61000-4-2,3,4,5,6,8,11;

OTHERS

MTBF (MIL-HDBK-217F)

More than 200,000Hrs (25C, full load)

Dimension (L*W*H)

208*60*30mm

Packing

TBD

Cooling method

Free air convection

NOTE

1.    All parameters NOT specially mentioned are measured at rated input, rated load and25℃of ambient temperature.

2.    Measured at 20MHz of bandwidth by using a12”twisted pair-wire terminated with a 0.1 uF & 100uF parallel capacitor.

3. he SPS is considered a component which will be installed into final equipment. We cannot guarantee that the final equipment will meet EMC directives, Final product manufactures must be re-confirm that their product meets EMC directives.