Ø Universal AC input (90~264Vac)
Ø With Active PFC, PF>0.95
Ø Surge 300Vac for 60S
Ø High Efficiency, long life and High reliability
Ø Output protections: OLP/OVP/SCP/OTP/OPP
Ø 1+1 parallel function, current sharing
Ø Wide operating ambient temperature (-40℃~65℃)
Ø Operating altitude up to5000m
Ø All using 105℃ long life electrolytic capacitors.
Ø 100% full load burn-in test
Ø Fanless, quiet working
Ø PCB with conformal coating
Ø 3 years warranty
|
MODEL |
VAT-UP200S-4.6-P |
VAT-UP200S-5-P |
|||
|
OUTPUT |
DC Output |
4.6V |
5V |
||
|
Rated Current |
40A |
40A |
|||
|
CurrentRange Note 1 |
0~40A |
0~40A |
|||
|
Peak load |
50A(50mS, 220Vac input) |
48A(50mS, 220Vac input) |
|||
|
Ripple and Noise Note 2 |
0~65℃ |
≤150mV |
≤150mV |
||
|
Voltage Accuracy@-20~65C |
±3% |
±3% |
|||
|
Line Regulation/ |
±0.5% |
||||
|
Load Regulation |
±2% |
||||
|
Set-up Time @25℃ |
≤2S (220Vac input,40A) |
||||
|
Hold up Time |
≥5mS (220Vac input,32A) |
||||
|
Temperature Coefficient |
±0.03%/℃ |
||||
|
Overshoot and Undershoot |
<5.0% |
||||
|
Parallel (current sharing) |
Current-unbalance< 10% (single PS drive40Aload, the voltage of current share bus is 5~6V) |
||||
|
INPUT |
VoltageRange Note 3 |
90Vac~264Vac |
|||
|
FrequencyRange |
47Hz~63Hz |
||||
|
Efficiency ( Typical) |
110Vac |
87% |
89% |
||
|
220Vac |
88% |
90% |
|||
|
AC Current (max.) |
<3.5A |
||||
|
Inrush Current (Typical) |
<15A@220Vac Cold start |
||||
|
Power Factor @25℃ |
>0.95 (input 220Vac,40A) |
||||
|
Stand by power consumption |
<4W (input 220Vac) |
||||
|
Leakage Current |
Input—output:<0.25mA Input—PG:<3.5mA (input 264Vac, 63Hz) |
||||
|
PROTECTION |
Over Load |
44~65A, hiccup mode, auto recovery |
45~55A, hiccup mode, auto recovery |
||
|
Over Power |
193~299W, hiccup mode, auto recovery |
225~275W, hiccup mode, auto recovery |
|||
|
Over Voltage |
5.1~7V, hiccup mode, auto recovery |
5.2~6.5V, hiccup mode, auto recovery |
|||
|
Over Temperature |
105℃+10℃(detect on temperature controller of PFC);shut down, auto recovery after the temperature goes down to75℃ |
||||
|
Short Circuit |
Long-term mode, auto recovery |
||||
|
ENVIRONMENT |
Operating amb. Temp. & Hum. |
-40℃~65℃; 20%~90%RH No condensing(refer to the derating curve) |
|||
|
Storage Temp. & Hum. |
-40℃~85℃; 10%~95%RH No condensing |
||||
|
SAFETY &EMC (Note 4) |
Safety Standards |
UL60950-1 2ndEd; IEC 60950-1:2005(2ndEd) ;EN60950-1:2006 |
|||
|
Withstand Voltage |
Primary-Secondary: 3.0KVac/10mA .Primary-PG:1.5KVac/10mA. Secondary-PG: 0.5KVDC/10mA. |
||||
|
Isolation Resistance |
10Mohms |
||||
|
EMI Conduction&Radiation |
Compliance to EN55022, EN55024, FCC PART 15 CLASS B |
||||
|
Harmonic current |
Compliance toEN61000-3-2CLASSD |
||||
|
EMSImmunity |
Compliance toEN61000-4-2,3,4,5,6,8,11; |
||||
|
OTHERS |
MTBF (MIL-HDBK-217F) |
>200000h (25℃, Full load) |
|||
|
Dimension (L*W*H) |
210*50*29mm |
||||
|
Packing |
28PCS/CTN, 0.04CBM |
||||
|
Power Good Signal |
Working properly: 3.3V |
||||
|
Working abnormally: <0.7V |
|||||
|
Reverse voltage start |
4.6V output |
When output reverse voltage is 5~5.1V, PS starts normally. |
|||
|
5V output |
When output reverse voltage is 5~10V, PS starts normally. |
||||
|
Cooling method |
Cooling by free air convection |
||||
|
NOTE |
1. All parameters NOT specially mentioned are measured at rated input, rated load and 25℃of ambient temperature. 2. Measured at 20MHz of bandwidth by using a 12” twisted pair-wire terminated with a 0.1 uF & 47uF parallel capacitor. 3.The power supply is considered as a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. For guidance on how to perform these EMC tests, please refer to “EMI testing of component power supplies” onhttp://www.powerld.com.cn. |
||||