Ø Universal AC input
Ø Built-in active PFC,PF>0.95
Ø High efficiency, long life and high reliability
Ø Output protection: SCP/OLP/OVP/OPP
Ø Wide operating ambient temperature (-20~65℃)
Ø All using105℃long life electrolytic capacitor
Ø 100% full load burn-in test
Ø 3 years warranty
|
MODEL |
VAT-UP200U-5 |
||
|
OUTPUT |
DC Output |
5.0V |
|
|
Rated Current |
40A |
||
|
CurrentRange Note 1 |
0~40A |
||
|
Peak load |
45A (50mS, 220Vac input) |
||
|
Ripple and Noise Note 2 |
0~65℃ |
≤250mV |
|
|
-20℃ |
≤300mV |
||
|
Voltage ADJ. Range |
/ |
||
|
Voltage Accuracy |
±4.0% |
||
|
Line Regulation |
±0.5% |
||
|
Load Regulation |
±2.0% |
||
|
Set-up Time |
≤2S (220VAC input, 40A) |
||
|
Hold up Time |
≥5mS (220Vac input, 32A) |
||
|
Temperature Coefficient |
±0.03%/℃ |
||
|
Overshoot and Undershoot |
<5.0% |
||
|
INPUT |
VoltageRange |
90Vac~264Vac |
|
|
FrequencyRange |
47Hz--63Hz |
||
|
Power Factor(Typical) |
PF＞0.95/230VAC full load |
||
|
Efficiency ( Typical) |
≥89%（220VAC, 40A） ≥87%（110VAC, 30A） |
||
|
AC Current (max.) |
<2A |
||
|
Inrush Current (Typical) |
<60A@230Vac Cold start |
||
|
Leakage Current |
Input—output:<0.25mA Input—PG:<3.5Ma (264Vac, 63Hz) |
||
|
PROTECTION |
Over Load |
44~65A, Hiccup mode, auto recovery |
|
|
Over power |
220~320W, hiccup mode, auto recovery |
||
|
Short Circuit |
Long-term mode, auto recovery |
||
|
ENVIRONMENT |
Operating amb. Temp. & Hum. |
-20℃~65℃; 20%~90%RH No condensing (refer to the derating curve) |
|
|
Storage Temp. & Hum. |
-40℃~85℃; 10%~95%RH No condensing |
||
|
Vibration |
10 ~ 500Hz,2G10min./1cycle, period for 60min. each along X,Y, Z axes |
||
|
Withstand Voltage |
Primary-Secondary: 3.0KVac; ≤10mA .Primary-PG: 1.5KVac; ≤10mA. Secondary-PG: 0.5KVDC; ≤10mA. |
||
|
Isolation Resistance |
10Mohms |
||
|
SAFETY&EMC (Note 3) |
EMI Conduction & Radiation |
Compliance to EN55022, EN55024, FCC PART 15 CLASS B |
|
|
Harmonic Current |
Compliance to EN61000-3-2, Class D |
||
|
EMSImmunity |
Compliance to EN61000-4-2,3,4,5,6,8,11; heavy industry level |
||
|
OTHERS |
MTBF (MIL-HDBK-217F) |
More than 100,000Hrs (25℃, Full load) |
|
|
Dimension (L*W*H) |
210×31.5×30mm |
||
|
Packing |
49PCS/CTN, 15KGS, 0.04CBM |
||
|
Cooling method |
Cooling by air |
||
|
NOTE |
1. All parameters NOT specially mentioned are measured at rated input, rated load and25℃of ambient temperature. 2. Measured at 20MHz of bandwidth by using a12”twisted pair-wire terminated with a 0.1 uF & 47uF parallel capacitor. 3.The power supply is considered as a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. For guidance on how to perform these EMC tests, please refer to “EMI testing of component power supplies” onhttp://www.powerld.com.cn. |
||